Application Instructions

VroomLite Classic Headlight Restoration Kit

 

Step 1:
Remove the kit contents, put on the POLY GLOVES and obtain the WHITE cloth.

Step 2:
Rinse one headlight fixture with water and thoroughly dampen the WHITE cloth.

Step 3:
Carefully open one Secret Sauce packet. Using one hand place the WHITE cloth over the tip of the fingers and apply the Secret Sauce onto the tip of the cloth.

Step 4
Using the WHITE cloth apply a little “elbow grease” and scrub the entire fixture with the Secret Sauce for 1 to 2 minutes using circular, vertical and horizontal motions to remove the oxidation.

Step 5
Rinse the fixture with clean water and visually inspect it to determine if additional cleaning is required. If no additional cleaning is required, proceed to step 6.

Step 6:
Completely dry the fixture with a separate towel (DO NOT use either of the towels in the kit).

Step 7:
Open one Clear Coat packet and apply a portion onto the YELLOW APPLICATOR PAD and then apply it to the entire surface of the cleaned dry fixture (similar to applying wax to a car; allow it to completely dry on the fixture for 2 minutes).

Step 8:
Using the BLUE towel buff the Clear Coat from the fixture by rubbing the lens in circular, horizontal and vertical motions (as you would buff wax on a car).

Step 9:
Repeat steps 2 – 8 on the opposite headlight fixture.

 

 

 

VROOMLITE "ERASE ALL"

 

Step 1:
Carefully remove the contents of the kit.

Step 2:
Obtain the white terry cloth and soak it in water. Twist the cloth to remove excess water.

Step 3:
Obtain the Erase All cleaner packet and lightly massage it with your fingers for 15 to 20 seconds.

Step 4:
Locate the small snip opening on the Erase All packet and gently tear it open.

Step 5:
Place the terry cloth over your index and middle finger and squeeze a small amount of the Erase All solution onto the tip of the cloth.

Step 6:
Apply a thin layer of the Erase ALL solution to the affected area (paint transfer deposit, scuff mark or minor scratch area) and let it sit for 30 seconds.

Step 7:
Apply firm pressure to scrub and rub the solution into affected area using circular, vertical and horizontal motions for one to two minutes.

Step 8:
Wash and rinse off the affected area with soap and water.

Step 9:
Visually inspect the affected area to determine if additional Erase All solution is required. If required, repeat steps 5 through 8.

Step 10:
If no additional cleaning is required proceed to dry the affected area with a towel and apply a paste wax (if desired). Paste wax is not included.